freestyle dash 3 xbox 360 complete guide

FREESTYLE DASH 3 XBOX 360 COMPLETE GUIDE PATCH

FREESTYLE DASH 3 XBOX 360 COMPLETE GUIDE PATCH

Of the CAT5 Patch Lead, separate the wires and prepare them for What we want to do here, is strip one end

We will prepare the DB25 Male Plug First.Study the image below.

2 x Switching Diodes for later on: Part No: BAT41 or 1N4148 or 1N4153.

5 x 100ohm Resistors (as per the image above).

1 x DB 25 25 WAY Male Plug (LPT Printer Cable) + Hood Cover.

1 x CAT5 Patch Lead (make sure it's CAT5 not CAT6).

Images below of whatĬontents Required to build this JTAG XBOX 360 cable (easily found at your local electrical outlet) The Xbox 360 Console and write the new image back. Now moving on.we'll next need to createĪ simple DB-25 to RJ45 Cable to allow us to dump the NAND image from 0 or lower, let's proceed to the next step, building the NANDīUILDING LPT/RJ45 CABLE FOR YOUR XBOX 360 CONSOLE To check your Xbox 360 Dashboard Version:ġ) Turn on your Xbox 360 Console and go to Console Settings:ĭashboard is on your top right (note in the image below i have kernel

Even if yourĬonsole has the right kernel version, we cannot confirm if it isĮxploitable until you dump an image of your NAND, but there is a very If you have an updated kernel, STOP RIGHT HERE andĭon't waste your time, your console is not JTAG-able. You will need an Xbox 360 Console with a Dashboard Kernel Version of.PC with a parallel printer port required to dump/write the NAND image.Complete step by step procedure with pictures to guide you Allowing you to run homebrew applications and backup games on your Xboxģ60 Console.

Freestyle dash 3 xbox 360 complete guide